高压清洗机的冲洗能力强，能去除地面等物体表面的污垢与油污渍等。小编特地整理一份高压清洗机的使用说明，方便大家随时随地查询。高压清洗机的使用说明如下：

High pressure washing machine has strong washing capacity, and can remove dirt and oil stains on the surface of objects such as the ground. I specially compiled a manual for the use of high-pressure cleaning machine, which is convenient for you to inquire at any time and anywhere. The operating instructions of the high-pressure washer are as follows:

1、接好高压清洗机的电源开关；

1. Connect the power switch of the high-pressure washer;

2、通电时，主要要把喷枪打开，避免出现回流水现象和机器发热；

2. When the power is on, the spray gun should be turned on to avoid backflow water and machine heating;

3、初次使用高压清洗机时，使用够20个小时后更换机油（机油用摩托车机油就可）；

3. When using the high-pressure washer for the first time, change the engine oil after 20 hours of use (motorcycle engine oil is enough);

4、第二次以后，使用100个小时后更换一次机油；

4. After the second time, replace the engine oil after 100 hours of use;

5、冲洗时，压力慢慢加大，不要一次加到大，以避免机器发热；

5. During flushing, the pressure shall be increased slowly, not at one time, to avoid heating of the machine;

6、冬天使用时，注意要涂防冻液；

6. When using in winter, pay attention to applying antifreeze;

7、加机油时，注意加油量，加到油缸规定红线稍高就可；

7. When adding oil, pay attention to the amount of oil, and add it to the specified red line of the oil cylinder slightly higher;

8、冲洗时，切忌将水枪对着人，以避免伤人；

8. When washing, never point the water gun at people to avoid injury;

9、间歇式冲洗时，停枪的时间不要超过2分钟，以避免回流、机器发热；

9. During intermittent flushing, stop the gun for no more than 2 minutes to avoid backflow and machine heating;

10、停机时，注意先关电源。

10. When shutting down, turn off the power first.

CNC高压清洗机日常操作与使用说明的相关内容我们就讲解到这里了，您对此有什么想咨询的问题就来我们网站咨询看看吧！

This is the end of the daily operation and use instructions of the CNC high-pressure washer. If you have any questions, please come to our website for consultation!