使用合符设备规格的电源及电源线

Use power supply and power cord conforming to equipment specifications

根据要求需要连接到接地线，清洗剂应放置在清洁、干燥、腐蚀性强的气体环境中，避免剧烈振动，发电机的后部应留下足够的散热空间。以确保超声波清洗机有良好的接触，避免发生人身伤害事故。

According to the safety requirements, it is necessary to connect to the grounding wire. The cleaning agent should be placed in a clean, dry and highly corrosive gas environment to avoid violent vibration. Sufficient heat dissipation space should be left at the rear of the generator. To ensure that the ultrasonic cleaning machine has good contact and avoid personal injury accidents.

严禁空载状态下开机

It is forbidden to start the machine under no-load condition

超声波清洗机开机前须使用说明的液位将清洗液倒入清洗槽中。被清洗物不得和槽底接触，建议将工件放入篮筐中清洗。清洗液不得呈强酸或强碱性，无可靠的措施时，不能使用易燃溶液。清洗液在一年中的温度会随着连续工作时间的延长而增加，超声波清洗机连续工作的时间不应超过规定时间。

Before starting the ultrasonic cleaning machine, the cleaning liquid must be poured into the cleaning tank with the liquid level specified. The object to be cleaned shall not contact with the bottom of the tank. It is recommended to put the workpiece into the basket for cleaning. The cleaning solution shall not be strong acid or strong alkaline. Flammable solution shall not be used without reliable safety measures. The temperature of the cleaning solution in a year will increase with the extension of the continuous working time. The continuous working time of the ultrasonic cleaning machine shall not exceed the specified time.

设备采用不燃性洗净剂

Non combustible detergent is used for the equipment

由于一些特殊原因需要使用易燃易爆易挥发的溶液作为介质时，会因为超声波清洗机开始工作的时候，超声波换能器会以每妙震动4万次的频率震动。

When it is necessary to use flammable, explosive and volatile solutions as media for some special reasons, the ultrasonic transducer will vibrate at a frequency of 40000 times per minute when the ultrasonic cleaner starts to work.

当超声波换能器以如此高的频率震动的时候自然会产生大量的热量，这些热量通过槽体散发，然后传到清洗溶液之中，清洗溶液温度开始提高，然后加速挥发速度，当空气中的溶液浓度达到一定的值的时候，再碰到因振动而达到一定高温震子，或者是发热块的时候，就是发生燃烧，或者爆炸。

When the ultrasonic transducer vibrates at such a high frequency, a large amount of heat will naturally be generated. These heat will be radiated through the tank body and then transferred to the cleaning solution. The temperature of the cleaning solution will start to increase, and then the volatilization speed will be accelerated. When the concentration of the solution in the air reaches a certain value, it will encounter a certain high-temperature vibrator or heating block due to vibration, which means combustion or explosion.

山东超声波清洗机厂家建议不要把需要清洗的东西放在底端，应该要用专门清洗的支架进行架空放在中间的位置，这样一来在进食的时候就可以均匀的受力获得好的清洗效果。同时高端的超声波清洗机厂家提醒还要注意到所放入的清洗液能量也应该要控制好，不能放太少否则可能会损坏仪器或者出现故障。

Shandong ultrasonic cleaning machine manufacturer recommends that the things to be cleaned should not be placed at the bottom end, but should be placed in the middle with a special cleaning bracket overhead, so that when eating, you can get a good cleaning effect. At the same time, the manufacturers of high-end ultrasonic cleaning machines remind that the energy of the cleaning liquid should also be well controlled, and not too little, otherwise the instrument may be damaged or malfunction may occur.

更多关于该设备的使用问题就来我们网站咨询了解吧。

For more information about the use of this equipment, please visit our website .